Valve influence on the power requirement of centralized pumps in hydronic heating systems - Theoretical study and evaluation of MathModelica as a hydronic systems simulation tool

Examensarbete för masterexamen

Please use this identifier to cite or link to this item: https://hdl.handle.net/20.500.12380/129256
Download file(s):
File Description SizeFormat 
129256.pdfFulltext1.49 MBAdobe PDFView/Open
Type: Examensarbete för masterexamen
Master Thesis
Title: Valve influence on the power requirement of centralized pumps in hydronic heating systems - Theoretical study and evaluation of MathModelica as a hydronic systems simulation tool
Authors: Gruber, Mattias
Abstract: This master thesis was performed in collaboration with the company Tour & Andersson AB (TA). The purpose was to evaluate if the systems modeling and simulation software MathModelica, can be used in the area of hydronic systems. The basis for the evaluation was a requirement specification, containing the following four requirements: 1. the software should find solutions to hydronic systems of relevant sizes, 2. the software should be able to be used to model both balancing and control valves as well as other common hydronic components 3. the software should be able to produce results which agrees to reality regarding systems behavior, and finally, 4. the software should be able to produce results which agrees to reality regarding numerical accuracy The evaluation was performed by executing two individual studies, which together were of such comprehensiveness that all four requirements were represented. One of these studies was called the verification study, and was used to test the fourth requirement presented above. The verification study was performed by model a test rig located at TA and to compare measured and simulated data. The result showed that the difference between the simulated and measured values normally was about ±7 %, which was considered as acceptable. However, much larger errors were also encountered in one case. For that reason, this requirement was not considered as fulfilled. The other study was called the reference study and was an evaluation of how ba-lancing and control valves in hydronic heating systems affect the power consumption of an including centralized pump. This study was used to test requirement one to three, and it was executed by modeling a general hydronic distribution system, as well as balancing and control valves. By simulating this system without any valves, only containing balancing valves and finally also with control valves, the effect that the gradual introduction of valves had on the drive power consumption of the pump was shown. Furthermore was the study broaden by including three different types of pumps as well as including both steady and unsteady conditions for which the power consumption was observed. The result showed that the power consumption of the pumps in all cases was decreased when valves were introduced. The primarily reason for this was that the flow level in the system was decreased enough to overcome any other negative effects. Hence, it was theoretically shown that the flowrate has the largest effect on the drive power consumption of a centralized pump. In conclusion, requirement three was considered as fulfilled, while requirements one and two were considered as fulfilled in most, cases but not in all, cases.
Keywords: Byggnadsteknik;Building engineering
Issue Date: 2009
Publisher: Chalmers tekniska högskola / Institutionen för energi och miljö
Chalmers University of Technology / Department of Energy and Environment
Series/Report no.: Examensarbete - Institutionen för energi och miljö, Avdelningen för installationsteknik, Chalmers tekniska högskola : E2009: 02
URI: https://hdl.handle.net/20.500.12380/129256
Collection:Examensarbeten för masterexamen // Master Theses



Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.