Dynamic Temperature Model of an Automatic Transmission

Examensarbete för masterexamen

Please use this identifier to cite or link to this item: https://hdl.handle.net/20.500.12380/256609
Download file(s):
File Description SizeFormat 
256609.pdfFulltext33.41 MBAdobe PDFView/Open
Full metadata record
DC FieldValueLanguage
dc.contributor.authorBerglund, Oscar
dc.contributor.authorZhang, Yao
dc.contributor.departmentChalmers tekniska högskola / Externsv
dc.contributor.departmentChalmers University of Technology / Externalen
dc.date.accessioned2019-07-03T14:59:35Z-
dc.date.available2019-07-03T14:59:35Z-
dc.date.issued2019
dc.identifier.urihttps://hdl.handle.net/20.500.12380/256609-
dc.description.abstractThis report presents the development of a dynamic temperature model for an automatic transmission in a Volvo Cars passenger vehicle. The model should simulate the oil to cooler temperature and flow from the transmission. A mathematical approach to use lumped masses for different parts of the transmission was used. These lumped masses were the oil, moving parts and house. To tune the response of the lumped masses and heat transfer coefficients, temperature measurements were used. Some existing measurements at Volvo Cars were tested, but these measurements were not accurate enough. New improved measurements on a vehicle in a chassis dyno were then performed. A decision to do measurements on all eight gears were made since the power losses were different on every gear. However the torque converter was open on the first gear, and could not be closed, which led to the decision to only test the remaining gears since the first gear will only be used during short times during most driving scenarios. To verify the model, simple drive cycles were performed with temperature measurement in the same chassis dyno and on the same vehicle. The verification on the model shows that the model can simulate the behaviour of a transmission with an error of 2.5 °C during normal behaviour and 6.5 °C for a few minutes, when a sudden change in the temperature from the cooler have a large transient increase. Because of this, the model is considered to be fairly accurate. However, in order to make the model compatible with Volvo Cars existing simulation software, Vsim, a "cooler model" has to be created.
dc.language.isoeng
dc.relation.ispartofseriesExamensarbete - Institutionen för mekanik och maritima vetenskaper : 2019:04
dc.setspec.uppsokTechnology
dc.subjectEnergi
dc.subjectTransport
dc.subjectHållbar utveckling
dc.subjectMaskinteknik
dc.subjectFarkostteknik
dc.subjectEnergiteknik
dc.subjectEnergy
dc.subjectTransport
dc.subjectSustainable Development
dc.subjectMechanical Engineering
dc.subjectVehicle Engineering
dc.subjectEnergy Engineering
dc.titleDynamic Temperature Model of an Automatic Transmission
dc.type.degreeExamensarbete för masterexamensv
dc.type.degreeMaster Thesisen
dc.type.uppsokH
Collection:Examensarbeten för masterexamen // Master Theses



Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.