CFD investigation of cooling flow in a rocket nozzle. A concept for one dimensional modeling with subdomains.

Examensarbete för masterexamen

Please use this identifier to cite or link to this item: https://hdl.handle.net/20.500.12380/165295
Download file(s):
File Description SizeFormat 
165295.pdfFulltext6 MBAdobe PDFView/Open
Full metadata record
DC FieldValueLanguage
dc.contributor.authorHansson, Lili
dc.contributor.departmentChalmers tekniska högskola / Institutionen för tillämpad mekaniksv
dc.contributor.departmentChalmers University of Technology / Department of Applied Mechanicsen
dc.date.accessioned2019-07-03T13:01:59Z-
dc.date.available2019-07-03T13:01:59Z-
dc.date.issued2012
dc.identifier.urihttps://hdl.handle.net/20.500.12380/165295-
dc.description.abstractThe main purpose of this work has been to study if it is possible to reduce the mesh resolution but still capture the general flow behavior and heat transfer in a rocket nozzle cooling channels by using a specific type of domain in computational fluid dynamics (CFD). The domain used in this work is a subdomain in the software Ansys CFX by the company Ansys. Ansys CFX is a software used to calculate fluid flow with the Navier-Stokes equations, so called CFD. The geometry that the investigations was conducted on were a square tube with a length of 4.2 [m] connected with a inlet manifold and a outlet manifold and 4 other tubes. In order to verify the results a simulation were preformed in the beginning of the thesis that were compared with Volvo Aero’s in-house code. The validation showed that, with the turbulence model SST k − ! and a friction loss coefficient, the temperature, pressure and velocity where matched with the simulation of the in-house code. After verifying the boundary conditions and mesh, the second part of the thesis were to investigate how well CFX handles the interface between a very coarse mesh and a very fine mesh. These results showed that the interface affects the result but the disturbances are sufficiently low for the purpose of the task. Finally the geometry with inlet manifold and outlet manifold and five tubes were simulated and evaluated in order to get a estimate of the time that it takes for the solution to converge. Comparing this simulation time with the time it takes for a fully resolved tube, the results showed a great improvement.
dc.language.isoeng
dc.relation.ispartofseriesDiploma work - Department of Applied Mechanics, Chalmers University of Technology, Göteborg, Sweden : 2012:37
dc.setspec.uppsokTechnology
dc.subjectInnovation och entreprenörskap (nyttiggörande)
dc.subjectStrömningsmekanik
dc.subjectRymd- och flygteknik
dc.subjectTransport
dc.subjectInnovation & Entrepreneurship
dc.subjectFluid mechanics
dc.subjectAerospace Engineering
dc.subjectTransport
dc.titleCFD investigation of cooling flow in a rocket nozzle. A concept for one dimensional modeling with subdomains.
dc.type.degreeExamensarbete för masterexamensv
dc.type.degreeMaster Thesisen
dc.type.uppsokH
Collection:Examensarbeten för masterexamen // Master Theses



Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.